I am posting an early design sketch of a 2m WSPR beacon. Here are the key points: 25 MHz HCI 0.5ppm TCXO powering the Si5351 module instead of the 26 MHz TCXO. If this fails, we can use a 10 MHz OCXO instead (a bit out of spec but works fine). Tokmas CID10N65F GaN FET might work @ 144 MHz as the 'final'. If not, use Mitsubishi RD15HVF1-501 MOSFET as backup. ...
I am posting an early design sketch of a 6m WSPR beacon. Here are the key points: 25 MHz HCI 0.5ppm TCXO powering the Si5351 module instead of the 26 MHz TCXO. If this fails, we can use a 10 MHz OCXO instead (a bit out of spec but works fine). Tokmas CID10N65F GaN FET should work @ 50 MHz TI UCC27614 or Onsemi NCP81074 gate driver Results: To be built and tested soon! ...
This ~1W to ~5W WSPR beacon runs continuously on the 10m band. It handles extreme environmental temperatures pretty well (it is 42°C plus here). Our article on this beacon's design and operation will appear in the May/June 2025 issue of the QEX magazine soon. References: http://www.carnut.info/WSPR_Tx/WSPR_Tx.htm
Ismo (OH2FTG) recently introduced me to a bunch of Tokmas RF parts. Out of these, the Tokmas CID10N65F GaN FET stood out. It seems to have a lot of potential (for HF + 6m) at a very low price point. This RF MOSFET part can be purchased from LCSC. It seems Tokmas CID10N65F has the potential to completely replace the RD16HHF1 part from Mitsubishi Electric! Datasheet excerpt: The full datasheet is available here. ...
I have designed, built and tested an all-HF WSPR beacon which produces 1W @ 5V and is rugged and cost-effective. Power consumption: Around 420mA @ 5V. Cost: Around 500 INR. Time to build: Less than 30 minutes. The files for this project are published here for personal (non-commercial) usage. For a 5W (QRO) WSPR beacon, please hold on for our upcoming QEX magazine article ;) Special shoutout goes to Brad (K1TE) for always pushing me to do better - thank you! ...
I have built probably the easiest, reasonably rugged and most cost-effective 100mW WSPR (or FT8) beacon. Here is my quick and dirty build with whatever I had laying around: We have replaced the traditional expensive Mini-Circuits transformer with a cost-effective Bourns coupled inductor. Power consumption: Before RF generation starts -> 20mA @ 5v. After RF generation starts -> 52mA @ 5v. So the power input consumed in the RF generation process is more than 150mW it seems (which is good). ...
I am building an easy-to-use and cost-effective WSPR pHAT for Raspberry Pi Zero 2 W. 3D render: We have replaced the traditional expensive Mini-Circuits transformer with a cost-effective Bourns coupled inductor. Results: To be built and tested soon! Time to build: Less than 20 minutes
Sometimes we all need a bit of QRO - Life's too short for QRP sometimes. So we give you the Baby-QRO switching amplifier! This Baby-QRO switching RF amplifier design is inspired by the wonderful Single NXP MRF-101 Eval Board project by Jim Veatch. Thank you Jim! Instead of using the expensive MRF101 MOSFET, we use fast SiC MOSFET(s) from Wolfspeed / SUPSiC. 3D render: Schematic: ...